APE Hanger™ Series 9/8

APE Hanger™ Series 9/8 loudspeaker rigging is designed around a 1 1/8″ (9/8″) diameter tube. It is a single-point system with low visual impact.

It is used in conjunction with user-provided schedule 40 steel pipe and/or steel framing systems like Unistrut. This combination creates a system that is flexible, safe, fast and affordable.

Because it is a single-point system, it is far less time consuming to make the structural connection amidst the jungle of other building elements like conduit, ductwork and sprinkler systems.

The APE Hanger™ can be used to install a speaker to within a few inches of a ceiling while retaining full adjustability of Pan, Tilt and Rotation angles. This is a great advantage when last minute adjustments to aiming angles are required. It also alleviates the need to know precise aiming angles prior to installation.

FAQs

small-divider
  • Q: What is the vertical pipe that the loudspeaker is attached to?
    A: 3/4 inch schedule 40 steel pipe. 1.05 inch outside diameter. This IS NOT thin wall conduit.
  • Q: Do you supply the 3/4inch down pipe?
    A: No, it is a User provided component. The length of this pipe determines the elevation of the loudspeaker above the floor. Since this need can range from very short to very long, it is best purchased locally by the user.
  • Q: Where can I purchase the 3/4inch down pipe?
    A: At any plumbing supply outlet or industrial supply house.
  • Q: Are your systems suitable for Outdoor installations?
    A: Our systems are intended for Indoor controlled environments only.